2 thoughts on “How can I install the stainless steel manhole cover”

  1. Hello, the installation method is as follows: 1: Check the net hole diameter of the well in the well should not be greater than the net hole of the well frame, so as not to be carried by the well frame and suspend the accident. 2: The relative height of the product plane and the surrounding ground should be Inside, it is wrong to exceed this range. 3: During the installation and use of the product, keep the front of the manhole cover. 4: The edge of the manhole cover can be pressed by stone or mixed with mud to keep the manhole cover fixing from displacement.

  2. The stainless steel stealth manhole cover is not a well -invisible manhole cover. When installing this stainless steel stealth manhole cover, first buried the manhole cover to the ground, and then the above stones were paved with the appearance of the surface. Because the manhole cover was buried in the ground, it was called an invisible manhole cover. Good anti -theft, aesthetics, practicality, and rust resistance.

    The first step: measure the size of the sewage port in advance, choose the stainless steel stealth manhole cover according to the actual size
    The sewage port of the road will be relatively smaller, and the sewage outlets on some large sections will be wider. When installing the stainless steel stealth manhole cover, be sure to measure the size of the sewage oral tubes in advance, and then buy a manhole cover of different sizes according to the actual size, so as to ensure the smoothness of the installation. If the size of the hidden manhole cover is different from the size of the sewage pipe, the installation will not continue.
    If: To determine the position of the stainless steel manhole cover, the base slot is reserved. The position of the manhole cover must be symmetrical with the culvert. There is a space of at least 150mm on the sides of it to make it easy for the concrete or mortar cushion;
    third step: Place the reserved position of the stainless steel manhole cover, and simply fix the concrete hole in the culvert. Fill in the outside of the stainless steel manhole cover and the good mortar. After adjusting the height, place the stone, and cut it according to the external texture structure;
    The fifth step: the key step: first place the inner frame of the stainless steel hidden manhole cover, the follow -up steps, the subsequent steps Same as the third part;
    Note: When putting in a stainless steel manhole cover, you should first clean up the debris in the stainless steel well to avoid affecting the flatness and the difficulty of opening in the future. When paving the cover, lay a 30mm thick cement mortar as a cushion, and then laid the stone. The lines and directions should be consistent with the overall ground during stone laying, so as to achieve invisible effects. Can play a beautiful effect.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top
Scroll to Top